Stake side replacement

A local delivery company did not like the usability of the stake sides on their flat beds.

Typical stake sides on flat bed

They had several concerns –

1.  With use the panels became out of square and so were difficult to take out and  put back in

2.  Loss of panels when they were miss placed

3.  Damage to panels when they were not removed and placed carefully in stacks

4.  Sometimes the panels would only fit in one location which at times made it difficult to put the panels back in if they didn’t remember where each came from.

We feel they now have a system which remedies these concerns

Hinged trailer side panels in the up and locked position

This is a 48 foot flat bed trailer, it has a total of 12 – 4’x8′ hinged panels on the sides.

Hinged Side Panel in the down position

Each Panel can be taken down individually

Close up of safety pin and sleeve welded into trailer rail, two of which are on each side panel

Each panel has the typical slide lock at the top corners but also has two safety pins at the bottom.  This allows the driver to unlock the panel at the top with out fear that the panel will swing down on its own.

Advertisements

Leave a comment

No comments yet.

Comments RSS TrackBack Identifier URI

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s