Bronze place marker repaired

We do quite a bit of work for a local cemetery, from working on their trailers to mowers.  This is a bronze place marker for one of the graves.  While mowing the lawns they drive over these place markers and eventually break off the bolt attachment.

all threads welded back on bronze place marker

Typically the heat from the welding would discolor the top side.  We remedy that by using several wet rags as a heat sink and put small stitch welds a little at a time on each all thread in rotation.

We used an aluminum bronze welding wire .035 diameter and straight Argon as the shielding gas.

Advertisements

1 Comment

  1. Sounds like you really know the welding tricks.


Comments RSS TrackBack Identifier URI

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

w

Connecting to %s